Default Tri-Fit Methodology:
Homegrown Certifications:
None Fit Bikes:
Bikefitting Motion-Capture Systems:
Other Brand-Friendly:
None Cost of Fit: $400 ($300 with bike purchase)
General Information
General Information: We can perform basic bike fits in store, or book you in for a complete fit at our nearby Sensei studio. Sensei is a proprietary process, developed through R&A Cycles? 40+ years experience mastering bike fit. The Sensei process is based on listening, teaching, calculations and intuition. Sensei is not just numbers, it is cutting edge technology and techniques, applied with the knowledge of the most experienced fit technicians on the planet. Directions: Manhattan Bridge: (10-15 minutes)
You can take the Manhattan Bridge right into Flatbush then make a left on Fifth. We are five blocks from there.
------From: Brooklyn Bridge:
Head straight off Bridge until you reach Atlantic Avenue. Make a left on Atlantic, then head down Atlantic to Flatbush and make a right. Immediately after make a left on Fifth and head straight five blocks.
------From NORTH:
Head down through the BQE to Tillary Street Exit (just before Manhattan Bridge) Make left on Flatbush and follow above Manhattan Bridge Directions.
------From LONG ISLAND:
Take LIE to the BQE S and then follow directions from the NORTH.
Alternate Route:
Take Belt Parkway towards BQE. Stay on right side of Gowanus Expressway (Risen Highway) and get off at Exit 38th Street. Make a left at first Light on 4th Avenue and drive all the way down to Baltic Street. At Baltic make a Right 1 Block. (Baltic is appr. 10 Blacks from 1st Street)
------New Jersey North:
Follow directions through Manhattan into Brooklyn or Manhattan Bridge
------New Jersey South:
Head towards Verazzano Bridge which leads right into the Gowanus Expressway. Get off at 38th Street Exit. Make a left at first Light on 4th Avenue and drive all the way down to Baltic Street. At Baltic make a Right 1 Block. (Baltic is appr. 10 Blacks from 1st Street)
Map location is based off of a geocode of the addressed entered using Google's Google Maps API. If your address does not geocode properly, you can either update the address (we will attempt to re-geocode after any updates to your entry) or you can use Google's geocoding tool found here: http://gmaps-samples.googlecode.com/svn/trunk/geocoder/singlegeocode.html to obtain a lat/long for your location and enter that. To use the utility, type in an address that is close to your location and then drag-and-drop the marker to obtain the desired lat/long. If you choose to enter a lat/long, you must check the box on the edit page that says, "override geocode with entered lat/long."